Start with the Distribution Duty
Medium-voltage switchgear is selected around the electrical system it must control, isolate, and protect, not by voltage label alone. Begin with the one-line diagram, nominal system voltage, frequency, phase arrangement, grounding method, source configuration, feeder destinations, transformer connections, and operating sequence. A useful medium-voltage switchgear selection also accounts for continuous load, expected load growth, available fault current, and whether the lineup serves a utility interface, a transformer primary, or several distribution feeders. Switchgear Builders manufactures new electrical switchgear in the United States, custom to project specifications, using American components and nationwide shipping. The final equipment scope remains subject to engineering review and project requirements.
Confirm Voltage Class and Insulation Coordination
System nominal voltage and equipment voltage class are related but are not interchangeable design entries. The specification should identify the system voltage, maximum operating voltage where applicable, grounding conditions, power-frequency withstand needs, and basic impulse insulation level when those values apply to the project. Insulation coordination considers the stresses imposed by switching events, lightning exposure, transformer connections, cable characteristics, and surge protection. Medium-voltage switchgear selection should therefore be checked against the complete distribution study rather than copied from a neighboring installation. Ask the engineer to identify required clearances, insulation systems, surge arresters, and test evidence before fabrication begins.
Match Switching and Protection Devices
Protective devices determine how a feeder or transformer is interrupted during an abnormal condition and how the system is restored afterward. Depending on the design, the lineup may incorporate circuit breakers, load-interrupter switches, fuses, instrument transformers, relays, metering, or control power equipment. Selection should reflect interrupting duty, continuous current, short-time withstand, transformer inrush, motor contribution, ground-fault behavior, and coordination with upstream and downstream devices. A protection engineer should define relay functions and settings from the study, while the manufacturer converts the approved requirements into compartments, bus connections, wiring, and documentation. Do not assume that a familiar device arrangement suits every feeder.
Plan Transformer and Feeder Interfaces
A medium-voltage lineup often sits between an incoming source and transformers, motors, or additional feeders, so physical interfaces deserve the same attention as electrical ratings. Provide transformer impedance, primary connection details, cable size and termination arrangement, phase sequence, grounding conductor requirements, and the intended routing into the equipment. Confirm whether the installation is indoor or outdoor, how conductors enter, what working and maintenance clearances are available, and how sections will be moved into position. For a custom build, accurate room dimensions, elevations, foundation information, and access constraints help align the enclosure and cable compartments with the installing contractor’s work.
Define Construction, Controls, and Documentation
The enclosure and lineup arrangement should follow the environment and operating method: indoor or outdoor exposure, access direction, compartment separation, mechanical interlocks, grounding provisions, control voltage, remote indications, and communications requirements. Drawings should show the one-line, elevations, plan dimensions, nameplates, device schedules, terminal points, and control logic. Include the expected operating sequence for source switching, feeder isolation, and any tie function so interlocks can be reviewed before release. If the project references UL 891, confirm whether that standard applies to the specific assembly and what project-specific listing, construction, and verification requirements must be met; applicability is not automatic for every medium-voltage design.
Prepare a Complete Manufacturer Inquiry
A productive inquiry for new medium-voltage switchgear includes the latest one-line diagram, equipment schedule, fault-current information, load calculations, transformer data, protection study inputs, site conditions, layout drawings, cable details, control schematics, metering requirements, and documentation expectations. State the desired lineup sections, access orientation, shipping splits, lifting or handling constraints, destination, and coordination responsibilities, while leaving ratings to the qualified design team where information is incomplete. Switchgear Builders can use the defined scope to develop custom equipment for U.S. projects and arrange nationwide shipping; project-specific availability, commercial terms, transit estimates, and any applicable standards must be confirmed in the quotation and submittal process.
